We study and develop electronic and connected solutions designed to measure, control, monitor and transmit useful information for technical and industrial operations.
An embedded system is an electronic and computing system designed to perform a specific function within a device or installation. It can collect measurements, process signals, trigger an action or transmit data.
At NISAN CORPORATION SARL, we approach every project from its actual requirements: operating environment, expected function, required interfaces, power supply, communication, installation constraints and maintenance needs.
Each architecture is defined according to the required functions, the equipment involved and operating conditions.
Design of solutions intended to read signals, apply operating logic, monitor status and communicate with compatible equipment.
Discuss a requirement ↗Vehicle, machinery and mobile equipment location and tracking using selected compatible devices.
Measurement acquisition and reporting for monitoring specified parameters.
Study of interfaces and protocols compatible with equipment and project constraints.
Architecture for collecting, transmitting and using data from connected equipment.
Control of specific functions, operator interfaces and communication between compatible devices.
Design of configuration, display or information access interfaces according to project needs.
A solution can be organized around several complementary functions. Their selection depends on the specification, and not every project requires every module.
Compatible sensors, contacts or interfaces provide signals and measurements about the monitored condition.
A processing device applies defined rules to interpret information and determine the required response.
Depending on the project, an output may control a compatible device or send a command to another piece of equipment.
Where specified, useful information is sent to a compatible interface or platform for viewing and monitoring.
Our studies can cover several environments. The final scope depends on technical feasibility, available equipment and the client’s objectives.
GPS / FLEET
Design of vehicle and mobile equipment tracking solutions, with data reporting according to the features supported by the selected devices.
INDUSTRY / IoT
Design of data acquisition and equipment parameter monitoring, subject to sensor and interface compatibility.
CONTROL / SAFETY
Design of electronic interfaces and signal exchange with compatible security systems, respecting the requirements of each installation.
ENERGY / DATA
Measurement acquisition or transmission solutions according to approved interfaces and installation safety requirements.
REMOTE / CONNECT
Design of communication methods and data transmission paths suited to network coverage, data volume and operating constraints.
CUSTOM / R&D
Preliminary design of solutions for a specific function, including constraints definition, technology selection and validation planning.
A progressive approach helps reduce ambiguity, identify constraints early and document technical decisions before deployment.
Define the problem, users, expected functions and operating conditions.
Determine the interfaces, power supply, communication and required components.
Implement the agreed electronic, software and interface functions.
Verify the planned functions, identify anomalies and document the results.
The quality of an embedded system goes beyond its initial operation. It also depends on component suitability, power stability, interface compatibility, installation environment and diagnostic capabilities.
Verification of applicable voltages, signals, interfaces and connection conditions.
Consideration, according to the project, of temperature, vibration, dust, humidity and electrical environment.
Description of functions, interfaces, parameters and procedures useful for operation and maintenance.
Definition of system limits and necessary protective measures according to the application.
Here are some guidelines for defining your needs and preparing an initial technical study.
It is an electronic and computing system integrated into equipment to perform a specific function, such as measuring a parameter, processing a signal, controlling an output or transmitting data.
Yes, a study can cover vehicle or mobile equipment tracking. Features, data availability, network coverage and interfaces depend on the selected devices and project scope.
This may be possible if the sensors, communication interfaces, processing device and application are compatible. A preliminary study identifies the required adaptations.
An assessment can be carried out using available references, diagrams, accessible interfaces and connection conditions. Any intervention depends on compatibility and applicable authorizations.
A description of the problem, desired function, equipment type, operating conditions, available technical references, power constraints and communication needs provide a good starting point.
The choice between an existing solution, an adaptation or a custom design is made after assessing requirements, feasibility, cost, timelines and technical constraints.
Present your requirements to NISAN CORPORATION SARL. We can define the initial steps for a technical study tailored to your project.